RECLOCK ENABLE BITPERFECT AUDIO FOR MAC OS
RECLOCK ENABLE BITPERFECT AUDIO INSTALL
RECLOCK ENABLE BITPERFECT AUDIO FULL

XMOS USB Audio Class 2.0 is supported by Apple OSX version 10.6. XMOS USB to coaxial, fiber optic I2S 384K USB DAC lcm | eBay zoe_tsang £33 'Things are in the right position, doing the right job'. Galvanic isolation (outputs, two oscillators and reclock are after the isolator) I2SoverUSB - I2S over USB Audio XMOS 500 MIPS processor I2S over USB Audio The interface can also be configured to use bus power only, useful for using the board as a simple USB to S/PDIF mobile interface. Critical components are powered by an external source to ensure optimal performances.

RECLOCK ENABLE BITPERFECT AUDIO FULL

Full galvanic isolation avoids any interference issues between the audio device and the USB host. Using this concept, the design benefits of a local high quality master clock to achieve jitter-free playback and bit-perfect data transfer.Įxternal master clock synchronization is provided for enhanced flexibility and optimal clock distribution.

USB streaming is based on an asynchronous protocol, clocked by low jitter on board oscillators. The Edel USB to I2S/SPDIF interface is an easy to integrate OEM solution for High End USB audio playback systems, supporting both USB Audio Class 1.0 and 2.0.

RECLOCK ENABLE BITPERFECT AUDIO FOR MAC OS

No drivers needed for MAC OS version 10.6.4 and above

RECLOCK ENABLE BITPERFECT AUDIO INSTALL

Diyer expert can remove FB1 and use 5V external power connect to CN1(warning: over-voltage or reverse-voltage can damage the xmos chip immediately, any modification void item warranty)ĩ) Extreme diyer can cut and install series resistor in the pre-allocated 0805 footprint space in the I2S line to match their DAC line impedance XMOS 384kHz high-quality USB to I2S PCB with ultralow noise 6.5uV regulator - DIYINHK diyinhkġ) Newest XMOS chip and uses 48MHz oscillator to asynchronous reclock usb audio data to I2S line, old XMOS uses only 13Mhz oscillator, over 4x better jitter rejection theoretically.Ģ) 6.5uVrms Ultralow noise linear power regulator (use of decade old LM317/1117 regulator is kidding for audiophile)ģ) Solid ground plane (a must for high speed digital circuit)Ĥ) No Via in active circuit (via inductance always create jitter problem)ĥ) FOX ultra low ppm oscillator and Murata capacitor sourced from Digikey USA (guarantee no fake product from China)Ħ) Gold plate USB connector (Molex, FCI, or other depends on stock)Ĩ) PCB is USB powered(default). XMOS 384kHz high-quality USB to I2S PCB with ultralow noise 6.5uV regulator | eBay diyinhk So I'd like to get one of the XMOS ones, but which one?Ĭan you give your experiences and recommendations? If you want silky smooth video playback with no audio distortion then setup ReClock with MPC-HC x86 under Options > External Filters > Add Filter, install and register madVR then setup the auto refresh rate switcher in either MPC-HC or madVR (they both support it) so that 23.97 fps switches to 24 Hz, 25 fps to 50 Hz and 30 fps to 60 Hz. I excluded the CM6631A interfaces because I have a Mac Mini as source and I believe it has issues with OSX. There are a few USB to I2S interfaces now available using the XMOS chip.

Reclock enable bitperfect audio